13
EN
Desk Fan FΤ-40EII
• Place the locking cap on the motor shaft
and tighten by turning it anti-clockwise
according to “TIGHTEN” indication until it
locks well into place.
• Lift the securing guides located on the front
protective cover from the main body of the
cover. Remove the small screw located
on the front protective cover and place the
cover onto the back protective cover.
• The front protective cover should be placed
on to the back cover so that the small holes
located on each of two covers, are aligned.
Then insert the small screw in the two holes
and secure the protective covers using a
nut.
• Finally, lower down completely the securing
guides on to the surface of the protective
covers.
: In order to avoid any
possible hazards, always place the
appliance on a flat, steady and dry
surface before using it.
• Before use the appliance make sure that
you have correctly assembled all the parts
of the appliance. Make sure that all parts
of the appliance are not damaged before
assembly and use.
• Adjust the head of the fan pointing to the
desired direction.
• Before you connect the appliance on
the supply mains, check that the voltage
indicated on the data plate of the appliance
corresponds to that of the voltage mains in
your home. If this is not the case, do not
use the appliance and contact one of the
authorized BENRUBI Service Center.
• Connect the power cord to the supply
mains.
• Press one of the buttons witch are located
on the bottom of the device according to the
desired speed:
1 = LOW SPEED
2 = MEDIUM SPEED
3 = HIGH SPEED
• To activate the oscillation press the
oscillation knob , downwards.
• To stop the oscillation, lift the oscillation
knob upwards.
• To turn the fan off, press the “0” button
• Then, unplug the appliance from the
electrical outlet.
: Always press the “0”
button position before you unplug the
appliance.
: Always unplug the
appliance when not in use.
: Always press the “0” button
to turn of the fan, and disconnect
the cord from the electrical outlet
before any cleaning or maintenance
operations.
• Light accumulated dust may be removed
from the fan with a soft cloth moistened
(not dripping wet) with a solution of mild
detergent and water. Dry the surface of the
appliance thoroughly with a soft dry cloth
before operating the fan.
: To prevent the risk of
electric shock, do not immerse the
appliance in water or any other liquid.
• Do not place and do not use the appliance
where it may get wet or come in contact
with water. Never plug the appliance in the
supplier mains in case that its surface is wet
or even damp.
To Next Page
Loading...