3. Place the filter (15 or 19) of your choice (without coffee) in the group (14). Rotate the group
counterclockwise to lock into place.
4. Place a cup on the detachable rack (13) and plug in the socket.
5. Press the ON/OFF power button (30). The power indication light (20) starts blinking and the
appliance enters in preheating mode. When the power indication light (20) stabilizes, the warm-up
is complete.
6. Place a jug under the nozzle (9) or on the detachable rack (13) and turn the steam/hot water
control knob (25) to position (23). Hot water will start running from the nozzle (9).
7. Allow some water to run and turn the steam/hot water control knob (25) to the middle position
“ ” (24).
8. Place a cup on the detachable rack (13) and press the “SINGLE” (32) or “DOUBLE” (33) button
to run hot water. The appliance will stop automatically.
Note: To avoid burns and injuries, do not place your arms or other parts of the body under the group
or the steam hot water nozzle.
9. Thoroughly clean the removable parts of the appliance with hot water.
Note:
• There may be noise when water is pumped for the first time. This is normal.
We recommend preheating the appliance, the group, the filter and the cup before making coffee,
so that the quality of the coffee is not affected by the cold appliance. Place the filter of your choice
in the group without adding coffee and press the single or double dose button. The hot water will
pass through the pipes of the appliance and will heat the group, the filter and the cup. When the
process is complete, you can make a wonderful coffee!
Make sure the steam/hot water control knob (25) is in the “ ” position before plugging in the
appliance.
1. Fill the water tank (6) with clean water. Make sure the water level does not exceed “MAX”
indication.
2. Press the ON/OFF power button (30). The power indication light (20) flashes and the grinder
indication (22) is on. The appliance enters preheating mode. When the power indication light (20)
stabilizes and all the lights on the control panel turn on, the warm-up is complete.
3. Remove the group (14) by turning it counterclockwise and insert the filter (15 or 19) of your
choice. Put the desired dose of coffee and press the coffee into the filter with the tamper (10).
Notes:
• For the single dose of coffee, it is recommended to put 13gr coffee powder and for the double
dose 19gr. The pressure with the tamper should be about 12.5kg.
• Never press the coffee too firmly as it will come out slowly and this will affect its color and flavor. If
you press too lightly, the coffee will flow very quickly and will become light.
4. Place the group (14) by turning it clockwise. Make sure it is securely fastened in place.
5. Place a cup on the detachable rack (13) under the group.
6. Press the “SINGLE” dose button (32) or the “DOUBLE” dose button (33).
7. When the desired amount of coffee is run into the cup the appliance will stop automatically.
Note: You can adjust the amount of doses (see section: "Adjust the coffee brewing".
8. When you have completed the procedure, press the ON/OFF button (30) and unplug.
9. Remove the group (14) by turning it counterclockwise and allow to cool before emptying the filter
of coffee.
To Next Page
Loading...
