10. Once the group (14) and filter (15 or 19) have cooled down, empty the filter and remove it from
the group.
11. After each use, empty the water tank and wash the group and the filter. See section "Cleaning
and care".
Notes:
• Do not use very finely ground coffee as it may clog the filters.
• Do not leave the appliance unattended while it is operating.
• The device automatically enters “SLEEP” mode after 20 minutes without operation. You can turn
on the appliance again by pressing the ON/OFF button. The appliance will return to preheating
mode.
Adjusting the Coffee Brewing
The appliance allows you to adjust the amount of coffee you make depending on your taste and/or
the size of your cups.
The coffee flow setting is programmed separately for the single or double brewing dose.
1. Press and hold the “SINGLE” (32) or “DOUBLE” (33) button. The corresponding indication light
flashes and the coffee flows.
2. When the coffee dose reaches the desired amount/density, release the button. A sound will be
heard.
3. The appliance is set to brew the amount of coffee according to your choice.
Note: The maximum single dose of coffee you can adjust is 120ml and the maximum double dose
of coffee is 220 ml.
Factory reset:
Press and hold ON/OFF+GRIND+SINGLE or ON/OFF+GRIND+DOUBLE until a beep sounds to
reset to factory settings.
Customizing Coffee Extracture Temperature
The appliance is equipped with a PID temperature control function to make sure that the coffee
extracted is at 92
o
C.
You can adjust the coffee extraction temperature to your preference. The temperature can be
adjusted between 88°C -96°C, increasing by 2°C each time, which can satisfy different taste
preferences:
-The higher the temperature, the bitterness of the coffee will increase and the acidity will decrease.
-The lower the temperature, the bitterness of the coffee will decrease and the acidity will increase.
1. While the appliance is in standby mode, press and hold the ON/OFF button (30) and the “SINGLE”
button (32). The power indication light (20) starts blinking.
2. Press consecutively the “GRIND” button (31) to decrease the temperature or the “SINGLE”
button (32) to increase the temperature.
To Next Page
Loading...
