In case of incorrect settings, you can reset the factory settings by pressing
ON/OFF+GRIND+SINGLE+DOUBLE at the same time. A beep will sound and the indication lights
will flash 3 times. The appliance has been reset to factory settings.
The device has a descaling reminder function and a descaling program. The descaling process
takes about 10 minutes.
When the water flow is reduced, the appliance enters the descaling mode automatically. It is
recommended to do descaling every 4-6 months depending on the use of the appliance.
Before the descaling process, make sure that:
1. There is at least 1 liter of water in the water tank (6).
2. Empty the detachable drip tray (11) and replace it.
3. Turn on the appliance and wait to reach standby mode.
4. Put the double dose filter (19) in the group (14).
5. Place the group (14) in the reception.
6. You can stop the descaling process at any time by pressing the ON/OFF button.
7. When descaling starts, the grinder indication (22) and the clean/preheat indication (22) will
flash throughout the process.
8. If descaling does not start within 1 minute, the appliance will exit the descaling cycle and return
to standby mode.
Descaling process
1. Add 1½ table spoon of white vinegar to the water container and add 1 liter of warm water to mix
the solution well.
2. Place the water tank.
3. Place a 1 liter container under the espresso maker and another 1 liter container under the steam
nozzle.
To Next Page
Loading...
