1. Prepare the espresso as described in "Espresso Preparation" section and make there is water in
the water tank and that the steam control knob (25) is in the “ ” position (24).
2. Add about 100ml of milk for each cup of cappuccino that you want to make in a metal jug.
• For best results, it is recommended that you use cold whole milk. Do not use compacted milk.
• The volume of milk can be increased up to 2 times, so you should choose a fairly wide and tall jug,
diameter not less than 7cm.
3. Turn the steam/hot water nozzle (9) to the right and place the metal jug with the milk under the
steam nozzle.
4. Immerse the steam nozzle about 2cm into the milk surface and turn the steam control knob (25)
to (26) position. The indication light (26) will turn on while the clean/preheat indication light
(28) will flash. The steam preheating process begins.
5. When the clean/preheat indication light (28) stays on and the indication light (26) flashes,
steam will be produced automatically.
6. Move the jug cyclically and upwards and downwards.
7. When the process is complete, turn the steam control to the “ ” position.
8. Stir the froth with soft circular motions and tap the pot on the bench.
9. Put the froth in the cup with the espresso using a spoon. Sprinkle with cocoa powder or cinnamon
if desired.
10. Clean the steam nozzle with a damp cloth or sponge immediately after each use with care not
to burn.
11. Press the power button “ON/OFF” (30) to turn off the appliance.
12. Remove the plug from the socket.
Note: If you do not turn the steam/hot water control knob (25) to the “ ” position (24), the steam
indication light (26) will flash and the other functions of the appliance will not be activated.
CAUTION! The steam function produces high temperature steam. Use with caution to avoid burns.
Notes:
• Never operate the steam/hot water function for more than 3 minutes at a time.
• Never allow the milk to reach boiling temperature to prevent the taste of cappuccino.
• If you want to make over 1 cup of cappuccino, first prepare the coffees and then the milk froth.
The appliance has a low water level reminder function when the water in the water tank (6) is low.
When the water level is low, the indication lights (20), (22), (27) and (29) a
continuous beep will sound. Remove the water tank and fill with water.
To Next Page
Loading...
