Note: The amount of coffee is appropriate when the edge of the tamper (10) is aligned with the edge
of the group (14).
8. Follow the steps in the "Espresso preparation" section to make your coffee.
Notes:
• When the coffee grinder container (3) is not in place, the grinder indicator light (21) is red and
flashing.
• When the grinder operation is not normal, the grinder indication light (21) flashes with three beeps
to protect the grinding system.
• Do not operate the coffee grinder for more than 3 consecutive minutes. If the operation exceeds
3 minutes, the mill stops automatically. The operation of the grinder returns after 6 minutes. If you
press the “GRIND” button (31) before 6 minutes have elapsed, three beeps will sound and the
grinding indication light (21) will flash.
• The appliance has a system that prevents ground coffee from overflowing during grinding. If the
coffee powder overflows from the group, use a brush to clean the excess coffee immediately.
Adjusting the Grinder Quantity
• The factory setting of the grinding time is for the double dose of coffee. The device produces about
19g. coffee powder (in about 14 seconds) at cutting degrees 5-10.
• You can adjust the grinding time to your preference.
1. After placing the coffee beans in the container and placing the group (14) in the group reception
(8), press and hold the “GRIND” (31) button (see section “Use coffee grinder”). The grind indication
light (21) will flash and the grind indicator (22) will remain on.
2. When the amount of ground coffee reaches the desired, release the button. A sound will be heard.
3. The appliance is set to grind the amount of coffee according to your choice.
Note: The minimum grinding time you can set is 5 seconds. The machine cannot be set for grinding
in less than 5 seconds.
Factory reset:
Press and hold ON/OFF+GRIND until a beep sounds to reset to factory settings.
Make sure the steam/hot water control knob (25) is in the “ ” (24) position before hot water is
prepared.
1. While the appliance is in standby mode, place a cup or jug under the steam/hot water nozzle (9).
2. Turn the steam/hot water control knob (25) to the hot water position (23). The indication light
(23) will flash to produce hot water while the power indication light (20) and grinder indication (22)
will be on. The remaining indications on the appliance will be off.
3. When the hot water cycle is completed, the appliance will stop automatically.
Note: The maximum amount of hot water is 180-220ml. If you want less, turn the hot water regulator
(25) to the “ ” (24) position earlier.
4. Turn the hot water control knob (25) to the “ ” position (24) when the appliance stops producing
To Next Page
Loading...
