• Make sure the appliance is switched off and unplugged before use.
• It is recommended to preheat the appliance for 5 minutes without food before cooking.
• Do not put a paper liner without food in the airfryer, to avoid it flying away or burning by the heating
element.
Regular function
- You can cook two different foods by choosing different program, temperature & time for each
one.
1. Place the appliance on a clean, flat and heat-resistant surface.
2. Place the rack (4) in the bucket (5) and slide the bucket separator (3) in the slot in the middle of
the bucket.
Note: Do not use the appliance without the detachable rack.
3. Place the food on the rack (4) and insert the bucket (5) in the reception until it snaps into place.
Note: Make sure the food in the bucket does not come into contact with the heating resistant.
Note: If the bucket with the rack do not fit well into the airfryer cavity, the appliance will not turn on.
4. Plug in. A “beep” will be heard and the power button (23) will remain on.
5. Press the power button (23). A “beep” will sound and all the indication lights on the control panel
(10) will turn on.
6. Press the zone selection button 1 (10). The indicator light will flash.
7. Press the button of the program of your choice (see section "Table of programs & preset times &
temperatures"). The corresponding indication light will flash and the preset temperature and the
preset time of the program will alternate on the display screen. Set the temperature and time of your
choice by pressing the corresponding temperature (9) and time (13) adjustment buttons.
8. Press the zone selection button 2 (12). The indicator light will flash.
9. Press the button of the program of your choice (see section "Table of programs & preset times &
temperatures"). The corresponding indication light will flash and the preset temperature and the
preset time of the program will alternate on the display screen. Set the temperature and time of your
choice by pressing the corresponding temperature (9) and time (13) adjustment buttons.
Note: If you do not press any key for 5 minutes, the lights will turn off and the appliance will enter
the standby mode and the power indication (23) will remain on.
10. Press the “START/PAUSE” button (16) and the appliance will start. The internal light will turn on.
Note: The internal light will remain on for 3 minutes and then will turn off.
11. On the display screen the selected temperature and time will alternate.
Note: During cooking, it is recommended to stir or turn the food in the bucket for best results:
- Press the START/CANCEL button (16), remove the bucket, mix and reinsert the bucket. Press
the START/CANCEL button again and the selected program will automatically resume.
Note: If you do not insert the bucket within 5 minutes, the selected program is cancelled. The lights
will turn off, the appliance will enter into standby mode and the power indication light (23) will remain
on.
12. When the selected program is finished, a “beep” will be heard 11 times. The indication lights will
turn off and the indication light of the power button (23) will remain on.
Note: If the times you have selected are different, when the shorter one is completed a “beep” will
be heard and the half side will stop working.
Note: Before serving, check that the food has been cooked. If it takes extra time to cook, repeat the
process by adjusting the time and temperature. Cooking time depends on the density, thickness
and humidity of the food.
To Next Page
Loading...