·3·
MADE IN CHINA
Troubleshooting:
Power LED is not on
Check the power adaptor connection between wall outlet and the
hub.
Check on USB 3.0 cable to ensure the proper connection in between
USB 3.0 input port on the hub and the USB port on the computer.
Computer does not recognise the hub
Check the connection of the USB 3.0 cable in-between the hub
and the computers USB port.
Try to plug the USB 3.0 cable into a dierent USB port on the
computer and to restart the computer.
Computer does not recognise the plug in USB device
Make sure that the on/o switch of the port is turned on.
USB device connected to dedicated charging port will not appear
on the system since the port is for charging only.
USB devices with high power demand may not work properly as
too much current may be drawn. The supplied external power
adaptor is used to provide sucient power to the hub.
Try connecting the USB device into a dierent USB port on the hub.
Detach the hub from the computer and remove the high power
demand USB devices. Refer to the rating label information for each
connected device. Each USB port is only rated for 5V 0.5A max
load.
Connection is slow
Make sure that the USB port on the
computer and connected devices to
the hub are in USB 3.0 specication.
•
•
•
•
•
•
•
•
•
•
To Previous Page
Loading...
General