J.W. Speaker J Series User Manual

Model 279 J Series
LED Jeep Tail Light Instruction Sheet
Tools Needed Phillips Screwdriver
Pliers OR Adjustable Wrench
Estimated Time 30 minutes
In the Box (x2) Model 279 J Series Tail Lights
A. (x2) Resistor Mounting Brackets
B. (x4) Tinnerman S-Clips
C. (x4) #4-40x0.312" Screws
D. (x4) #4-40 Lock Nuts
Regulatory Compliance
To properly install this light you should have a good understanding of automotive electrical procedures and
systems, and proficiency in the installation of tail lights. If you do not, please seek professional assistance.
INSTRUCTIONS BEGIN ON THE NEXT PAGE
Input Voltage
Operating Voltage
12-24V DC
Single lights come with half of the above parts
10-32V DC
Page 1
B
C
D
A
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • speaker@jwspeaker.com • 262.251.6660
6544230bRev: 05/19/2016
PRE-INSTALLATION INFORMATION
Pre-Installation Guidelines
1. Read all safety notes and mounting guidelines before installing
the product. Verify that all parts listed under “In the Box” are
present and complete.
2. Inspect the product for damage. DO NOT install the product if
there is any damage. Contact the authorized retailer where you
purchased it to initiate a warranty claim if there is damage.
3. Verify that all power supply and/or charging systems comply to
the specified voltage limits for the light.
4. Turn off the vehicle and disconnect the battery.
PRODUCT WARRANTY:
If you have issues with a J.W. Speaker
product, please contact the authorized
retailer where you purchased it.

J.W. Speaker J Series Specifications

General

Category	Lighting Equipment
Series Name	J Series
Manufacturer	J.W. Speaker
Lens Material	Polycarbonate
Voltage	12-24V DC (typically)
Housing Material	Aluminum
IP Rating	IP67
Color Temperature	5000K
Compatibility	Universal

Summary

PRE-INSTALLATION INFORMATION

Estimated Time

Details the estimated time required for installation.

Tools Needed

Lists the tools required for the installation process.

In the Box

Specifies the components included with the tail light kit.

Input Voltage

Indicates the acceptable DC input voltage range for the light.

Operating Voltage

Specifies the operating voltage range for the LED tail light.

Pre-Installation Guidelines

Installation Instructions

Resistor Installation and Safety Precautions

Resistor Temperature Warning

Alerts users that the resistor can reach high temperatures up to 330°F (165°C).

Important Resistor Handling Instructions

Lists critical instructions for resistor mounting and handling to prevent damage or warranty voidance.