5
english
JABRA BT2080
2 Set your Bluetooth phone to ‘discover’ the Jabra BT2080
- Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to discover new devices. This usually involves going
to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth device.*
3 Your phone will nd the Jabra BT2080
- Your phone will nd the headset under name “Jabra BT2080”.
Your phone then asks if you want to pair with the headset.
Accept by pressing ‘Yes’ or ‘OK’ on the phone. You may be asked
to conrm with a passkey or PIN. Then use 0000 (4 zeros). Your
phone will conrm when pairing is complete and the Bluetooth
status indication on the StatusDisplay™ will shift from ashing
light to steady light.
Manual pairing mode
If you wish to use the headset with a dierent phone, or if the
pairing process was interrupted, you can manually set the headset
to pairing mode.
Make sure the headset is on. Press and hold the answer/end
button for approximately 5 seconds until the Bluetooth icon turns
from a steady light to a ashing light. Then repeat steps 2 and 3 in
the above pairing guide.
ConneCtInG WItH YoUR PHone
Pairing is only needed the rst time a headset and phone are
used together. When the headset and phone have been paired
once, they will automatically connect when the headset is on and
Bluetooth is activated on the phone. The headset can be used
when it is “connected” to the phone. If the devices are paired, but
do not immediately connect, tap the answer/end button. When
your headset is connected the Bluetooth connection icon in the
StatusDisplay™ will be constant on for 3 seconds.
* Phone dependent
To Next Page
Loading...
Need help?
General
