How to connect my Jabra PRO / GO with Alcatel IP Touch
4028, 4038, 4068
Jabra GO 6470
Requirements:
Jabra LINK 14201-36
To connect your headset please follow these steps:
1. On the 2-sided end, plug the RJ45 connector (red band) in the red socket
marked AUX on the Jabra device base.
2. Plug the RJ10 connector (blue band) into the blue socket marked with
the phone symbol on the Jabra device base.
3. For the 2-fold Y coupling end, plug the 3.5 mm phone connector into
the headset interface.
4. Plug the RJ12 connector into the socket marked by a bell on the phone.
(The additional socket on the Y-coupling remains free to connect to an IP
device.
5. Then follow the instructions on the Jabra device touch-screen:
a. Select Phone settings.
b. Select Connect desk phone.
c. Select Manual.
To Next Page
Need help?
General
