JABSCO 60020-0000 - User Manual

Model 60020-Series
REMOTE CONTROL
SEARCH LIGHT
FEATURES
●
Constructed of noncorrosive ma te ri als
●
Sealed beam halogen lamp
●
Remote control and 15' cable in clud ed
●
Long life gear drive
●
Low amp draw
●
Patented clutch mechanism prevents motor damage
when running against limit stops
APPLICATION
Ideal for boaters...locate buoys, moorings, chan nel
markers, etc. Ideal for RV'ers...pin point road signs,
campsites, or use as backup light.
SPECIFICATIONS
●
320° horizontal movement
●
75° vertical sweep
●
50 watt 3-1/2" x 6" bulb
●
White thermoplastic housing and base
INSTALLATION INSTRUCTIONS
LIGHT MOUNTING
Select a location for the light which will allow for clear
beam projection forward and as far aft as pos sible.
Searchlight base should be mounted on level, flat
surface. Using the light base mounting template
enclosed, drill three (3) mounting holes and a center
hole at the center of base for wiring cable. Feed cable
through hole and fasten light in place with three (3) #10 x 1"
screws provided, or applicable screws for your particular
application. Mount light so that the Jabsco name on the
base is facing to the rear.
NOTE: SECURE CABLE WITH NYLON CLIPS OR
EQUIVA LENT. PROTECT INSTALLATION AT POINTS
OF STRESS, AND LEAVE ADEQUATE SLACK WHERE
CABLE MUST BE FLEXIBLE.
Remote Control Unit
Model Weights Standard
Number Voltage Amps Candlepower lb (kg) Carton
60020-0000 12 Vdc 3.6 100,000 6 (2.7) 4
60020-0024 24 Vdc 2 100,000 6 (2.7) 4
CONTROL INSTALLATION (60030-0000)
Select a location near the helm which will allow for
convenient operation of control.
1. Cut two holes (see Panel Cutout Template enclosed)
for mount ing control.
2. Route power leads (supplied by customer) from volt-
age source to control. Note: Wiring must be 16
gauge (mini mum).
3. Connect positive (+) power lead to red (+) wire and
negative (-) power lead to black wire using butt
connectors.
4. Connect wires (matching colors) from control panel
to end of light cable using butt connectors provided.
5. Use bedding compound or sealant to waterproof
control mounting.
6. Secure control with self-tapping screws provided.
Model 60020-Series 135 SL

Summary

REMOTE CONTROL SEARCHLIGHT

FEATURES

Lists key construction and performance characteristics of the searchlight.

APPLICATION

Describes ideal uses for boaters and RV users.

SPECIFICATIONS

Details movement range, bulb type, and housing material.

INSTALLATION INSTRUCTIONS

LIGHT MOUNTING

Specific steps for physically attaching the searchlight base to a level surface.

CONTROL INSTALLATION

Instructions for installing the remote control unit at the helm for convenient operation.

CONTROL UNIT OPERATION

SWITCH FUNCTIONS

Describes the operation of the Light Switch and Directional Switch.

CLEANING OF EXTERIOR PLASTIC SURFACES

Recommendation for cleaning plastic surfaces using warm water and mild detergent.

CIRCUIT PROTECTION

Details the location and replacement procedure for the 10 amp fuse.

BULB REPLACEMENT

Steps for removing the bezel, pulling the bulb assembly, and replacing the bulb.

SERVICE

CONTROL REPLACEMENT

Procedure for replacing switches on the control panel.

WIRING DIAGRAMS

135 SL CONTROL FRONT VIEW

Diagram showing wiring connections for the control unit.

DUAL STATION INSTALLATION KIT

Diagram illustrating wiring for a dual station setup.

TROUBLESHOOTING

Problem

Lists common issues and their corresponding solutions.

JABSCO 60020-0000 Specifications

General

Brand	JABSCO
Model	60020-0000
Category	Remote Control
Language	English