七、缝纫机调整（Sewing Machine Adjustment）
注意：为了防止机器突然启动造成人身事故，请关掉电源，确认电机确实停止转动
后再进行操作！
Attention: In order to prevent the machine from causing personal accident
suddenly, please turn off the power supply,confirm the motor really stop
running again then operate !
1、冷却器导线器的调整（cooler thread guide adjustment）
松开紧定螺钉，把各导线杆高度调整为图示的尺寸，然后拧紧紧定螺钉（图7-1），
针对不同布料时可通过调节A、B、C的高度来调节挑线量，导线杆的高度增加挑线
量减小，导线杆的高度降低挑线量增加（图1）。
Adjust the release pole hight to the number below, then tighten the set crew（Figure7-1），
Accounting to different fabric, we can change thread taking up length by adjusting pole
height of A、B、C，Thread taking up quantity increases when pole height decreases and
thread taking up quantity decreases when pole height increase.s（Figure 1）。
To Next Page
Loading...
