紧定螺钉：Set screw
图 12 (Figure 12)
注意：
1、下切刀组件完成调试后，需再次手动推动下切刀组件的定刀剪线，确认相对位
置准确，下切刀组件推出及复位均无卡点后方可重启电控，然后进行剪线。
2、当下切刀组件需要进行调整时，需确认针杆处于最高点，下弯针处于最右点，
然后方可手动推动下切刀组件确认相关位置。
Note:
1. After the lower cutter assembly is finished debugging, it is necessary to
manually push the cutter cutter of the lower cutter assembly again to
confirm the relative position is accurate. The lower cutter assembly is
released and reset without card point before restarting the electric control
and then cutting the wire.
2, when the current cutter assembly needs to be adjusted, be sure to
To Next Page
Loading...
