5
Mute Function
During the call, press
MUTE
once to stop the transmission for
handset and speaker – the mute LED will light up. Press
MUTE
again to resume the call – the mute LED will turn off.
Service buttons and MWI
1. To programme the service buttons or MWI: In on-hook
mode, press
PROG
+ programming number +
PROG
+
Service button. If you need, you can insert
FLASH
or
R
button.
In on-hook mode, press the relevant service button to see
the programmed number.
2. In on-hook mode: Pick up the handset or press , then
press the certain Service button, the programmed number
will be dialled automatically.
3. To delete the programmed number: In on-hook mode,
Press
PROG
+
PROG
+ Service button or MWI. If you need,
you can insert
FLASH
or
R
.
Set room number
In off-hook mode, press
PROG
+ room number +
PROG
+
or
.
The room number will appear in the left side
of the display.
In off-hook mode, pressing 13 0987654321
will delete all programmed numbers and the room number.
Caller ID
When receiving caller ID information the telephone can
recognize the format FSK & DTMF. This information will be
stored automatically. If you need to change the format, you
have to disconnect and re-power again.
The caller ID number will disappear within 30 seconds in
order to protect guest’s privacy. There are indicators for New
call, Repeat call, Secret call, Message and so on. It can store
48 incoming calls. The displayed number is up to 16 digits.
If the format is FSK, the date and time will be auto updated.
In DTMF mode, all settings won’t be changed. Furthermore,
the DTMF signal only includes incoming phone calls and
doesn’t include date and time.
Setting Date and Time
In on-hook mode: Press 11 MMDDHHmm .
MM: month (01-12)
DD: date (01-31)
HH: hour (00-23)
mm: minutes (00-59)
Message Waiting Indicator (MWI)
It is compatible with high voltage neon/90V and Lucent
low voltage system. Other MWI signalling systems must be
confirmed by the factory and implemented in production.
The MWI will flash if there is a message. Pick up the handset
or press the speaker , then press the MWI to retrieve the
message.
The MWI is also a ringing indicator, which will flash if there
is a call or a message.
Busy tone disconnect automatically
If the handset is not placed on the cradle after a phone call,
the telephone can automatically switch to on-hook mode
and the line will connect accordingly.
Data port
The data port can be used to connect computer, fax,
extension, etc.
Programming the service buttons by Cloner
1. Enter actively Remote Programming Status : Off hook
status, press for 5s of the base, the phone will send 3
dialing tones and the mute indicator flashes 3 times.
2. Escape actively Remote Programming Status: Off hook
status, press # for 5s of the base, the phone will send 3
dialing tones and the mute indicator flashes 3 times
Note:
- The phone will automatically escape the remote
programming status if the phone is successfully
programmed.
- Pressing the Volume button or back to on-hook status can
stop the programming work.
To Next Page
Loading...
Need help?
General
