16
Setting alarm time
1. When pressing the V ALARM SET the pre-set alarm time is
shown. The inner circle shows an alarm symbol. Press and
hold the V ALARM SET for a few seconds until the alarm
symbol starts to flash.
2. Release the V ALARM SET button quickly.
Press V ALARM SET again or TIME SET
V
until the Wake Up
Clock shows the desired alarm time.
3. Pressing the TIME SET
V
adds time and pressing the
V ALARM SET deducts time. Push and hold the button for
quick scrolling. Push momentarily for adding or deducting
time by one minute.
4. NOTICE: When the correct alarm time is obtained leave the
Wake Up Clock without touching any buttons. After a few
seconds the Wake Up Clock starts automatically and the
inner circle flashes once every second. The alarm symbol in
the inner circle indicates that the alarm is activated.
5. In order to view the alarm time just press either side of the
front button momentarily and the alarm time is shown for
a short moment.
Activate alarm
Press and hold the top-button "ON" for a few seconds until
the alarm symbol is shown in the inner circle. Release and the
alarm is then active.
Disarm the alarm
Press and hold the top-button "OFF" for a few seconds until
the alarm symbol in the inner circle disappears.
Alarm
When the alarm first goes off the back-light will be turned on
for a short moment and the alarm will sound for a maximum
of 2 minutes. After one minute the alarm will be more
intense. If the alarm is not turned off it will stop automatically
after 2 minutes.
How to use the SNOOZE function
When the alarm sounds a short press on either side of the
top button (less than 2 seconds) will switch the alarm off for
8 minutes. The SNOOZE function can be activated again and
again, silencing the alarm sound for 8 minutes each time.
When the alarm sounds or the snooze function is activated
the alarm symbol in the centre circle is flashing.
How to use the back-light
The back-light can be activated on demand by pressing either
side of the top-button momentarily. The light will turn off
automatically.
How to use the key lock
Locate the KEY LOCK slide-switch in the battery compartment.
If you push the switch "ON", all keys will be locked.
This function is useful when you travel in order to avoid an
unwanted pressing of keys, change of settings and subsequent
use of batteries.
Please note that the display on the product is a LCD (Liquid
Crystal Display) and for optimum readability of the display,
the product must be placed in a location with good lighting.
To Next Page
Loading...
Need help?
General