QUICK START GUIDE
en-10
DRIVING
HOW TO DRIVE
• Move the throttle control lever to the
FAST position.
• Release the brake - Make sure the park-
ing brake is completely released before
you move in a forward or reverse direc-
tion.
• Driving forward - Carefully press the top
(A) of the Forward / Reverse foot pedal
to reach the ground speed that you
need.
• Driving in reverse - Carefully press the
bottom (B) of the Forward / Reverse foot
pedal to reach the ground speed that
you need.
• To stop - carefully return the Forward /
Reverse foot pedal to the neutral posi-
tion then decrease throttle.
• To stop the vehicle on a slope it may be
necessary to apply traction in the oppo-
site direction to which the machine is
trying to roll.
HOW TO STOP
• Disengage the drive to the cutting units
with the cutting unit switch.
• Return the forward / reverse foot pedal
to the Neutral position.
• Set the parking brake.
• Move the throttle control lever to the
SLOW position.
• Turn the ignition key to the OFF position.
NOTICE
• Use complete foot to operate both forward and reverse.
• Always operate the traction pedal carefully.
• Do not move the pedal from forward to reverse quickly.
• Allow the machine to come to a stop before you engage reverse drive.
• When the parking brake is applied, DO NOT press the traction pedal.
To Next Page
Loading...
