GB-30
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
GB
10.9 ENGINE OIL LEVEL - GASOLINE
Damage to engines due to improper maintenance or
use of incorrect oil quality and/or viscosity is not
covered by the engine warranty (refer to the engine
operator's manual for crankcase capacity and
recommended oil grade and weight).
Unit must be on a level surface to obtain an
accurate oil level reading.
The oil level must be kept between the two marks on
the dipstick.
NOTE: DO NOT overfill. Engine overheating
and damage may result.
Figure 10.9
1. Oil Filler Port
2. Dipstick
10 LUBRICATION & MAINTENANCE
10.9.1 ENGINE OIL LEVEL - DIESEL
Damage to engines due to improper maintenance or
use of incorrect oil quality and/or viscosity is not
covered by the engine warranty (refer to the engine
operators manual for crankcase capacity and
recommended oil grade and weight).
Unit must be on a level surface to obtain an
accurate oil level reading.
The oil level must be kept between the two marks
on the dipstick.
NOTICE
DO NOT overfill. Engine overheating and
damage may result.
DO NOT use a wrench when installing the
filter, use hand pressure ONLY.
ENGINE OIL FILTER
When replacing the oil filter, apply a light film of
clean oil to the rubber seal. screw filter on until the
seal contacts the crankcase, then tighten 1/2 turn
more.
1
Figure 10.9.1
1. Dipstick
1
Figure 10.9.2
1. Oil Filler Port