en-106
10 QUALITY OF CUT
Do a “test-cut” to measure the performance of the
mower before you begin the repairs.
An area must be available for “test cuts.” Use this
area to give a base line with which to measure the
mower performance.
When the work is completed, repeat the “test-cut” to
check the mower performance.
The following items must be checked to make sure of
an accurate “test cut.”
1. Mowing (Ground) Speed
2. Blade Sharpness
3. Height-of-Cut (HOC)
4. Roller and Roller Bearing Condition
5. Blade Speed
6. Forward pitch of decks
10.1 QUALITY OF CUT PROBLEM SOLVING __________________________________
To Next Page
Loading...