en-24
5 CONTROLS
5.2.J DPF SWITCH ________________________________________________________
With the switch in the center position (default) it allows automatic Active Regen.
Operation of the mower is not changed during Active Regen. See 8.15
When the Regen Request light flashes, press and release the front part of the switch to
start the Parked Regen cycle.
To prevent damage to the turf during Parked Regen, park the mower on concrete or
gravel. The engine must be warm (above 65° C / 149° F), the traction pedal in
NEUTRAL position, PTO switch in OFF position and the parking brake engaged and
the throttle in idle position for the Parked Regen cycle to start.
Do not stop the engine, disengage the parking brake or drive the mower until the Regen cycle is completed and the Regen
Request light turns off. See 8.15
5.2.K AUXILARY HYDRAULIC SERVICES KIT SWITCH (OPTIONAL) _______________
Used to slew the rotary brush or snow blade to the right or to the left.
Push the front of the rocker switch to slew to the right.
Push the rear of the rocker switch to slew to the left.
5.2.L LIGHT SWITCH (OPTIONAL)___________________________________________
Allows manual operation of the road lights.
Position 1. OFF
Position 2. Side / Marker Lights
Position 3. Dipped Beam.
Note, Position 3 needs the ignition in the ON position.
5.2.M HAZARD WARNING SWITCH (OPTIONAL) ________________________________
Turns the four indicator lamps ON.
Push the front of the switch to turn ON
Push the rear of the switch to turn OFF
When the switch is turned on, the red lens flashes.
To Next Page
Loading...
