en-45
5 CONTROLS
5.2.Z.63 WARNING SERVICE NEEDED _____________________________________
When this screen is shown, the machine has reached a service interval as shown in the
maintenance chart
Press the button below the
to confirm the fault.
5.2.Z.64 WARNING SOLENOID FAULT _____________________________________
When this screen is shown, there is a hydraulic circuit solenoid fault.
Go to i/o diagnostics for solenoid identification.
Press the button below the
to confirm the fault.
5.2.Z.65 WARNING (TST) TILT SENSOR TECHNOLOGY FAULT _________________
When this screen is shown, there is a fault with the TST. Stop as soon as possible and
contact your service dealer
Press the button below the
to confirm the fault.
5.2.Z.66 WARNING MAXIMUM SLOPE ANGLE EXCEEDED_____________________
When this screen is shown, the maximum-slope angle has been exceeded.
Press the button below the
to confirm the fault.
1
!
SERVICE
REQUIRED
1
!
TST
™
1
0°
Slopes > = 25°
in either x or y
To Next Page
Loading...