en-91
MAINTENANCE AND LUBRICATION 8
Check The Engine Coolant Level
(a) The level of coolant in a cold expansion tank must be between the
indicators.
(b) If you need to fill the tank, remove the plastic cap and fill with the
correct anti-freeze mixture (see section 8.1).
(c) Replace the plastic cap.
How To Change Coolant
(a) To drain coolant, remove the bottom hose (A) from the radiator. Drain
the engine coolant into a container.
(b) Replace the bottom hose (A) on to the radiator. Make sure all the
hose clips (B) are tight.
(c) Fill the cooling system with the correct anti-freeze mixture, see
section 8.1. Fill system through the radiator cap.
(d) The level of coolant in a cold expansion tank must be between the indicators.
(e) Run the engine for approximately 5 minutes or until the thermostat opens.
(f) Check the level of coolant in expansion tank. Fill the tank if more coolant is needed.
CAUTION
The Anti-freeze Can Damage Your Skin. Use Gloves When You Use Anti-freeze. If Anti-freeze Touches
Your Skin, Clean The Area Immediately.
CAUTION
Discard Anti-freeze As Shown In Local Safety Regulations.
To Next Page
Loading...
Need help?
General
