1 2 3 4 5
8
The maintenance free, Lithium Ion battery in your pool cleaner must be properly disposed of in accordance to State and local law. To
conrm if recycling is required; contact your local authority for information.
WARNING!
• Never attempt to disassemble a battery pack.
1. Remove all personal items such as rings, bracelets, necklaces and watches when unwiring a pack from the vacuum unit.
2. A battery can produce a short circuit current high enough to weld a ring (or like item) to metal causing a severe burn.
3. Wear complete eye protection, gloves and protective clothing when removing the battery pack.
4. Take care not to touch wires together or allow them to contact any metal items, which would cause sparking and/or short
circuit the battery.
5. Never smoke or allow a spark or ame in the vicinity of the battery or the cleaner. Batteries can generate gases which could
possibly ignite.
6. Do not expose to re or intense heat as this may result in an explosion.
CAUTION!
• If a battery leak develops, avoid contact with the leaking acid and place the damaged battery in a plastic bag.
7. If acid comes in contact with skin and clothing, wash immediately with plenty of soap and water.
8. If acid comes in contact with eyes, immediately ood eye with running cool water for at least 15 minutes. Get medical
attention immediately.
How to remove the battery
• Recommended tools (not included): Philips screwdriver, wire-cutters, electrical tape.
1. Remove battery chamber cap.
2. Using the Philips screw driver, unfasten the 2 screws on top of the motor-box.
3. Pull the battery out shown in image three.
4. Using the wire-cutters, cut the wires as shown in image four. Do not cut both wires at the same time.
5. Wrap the wires with electrical tape. Dispose according to local law.
END OF LIFE BATTERY DISPOSAL
To Next Page
Loading...
Need help?
General
