40
Lumbar hydromassage
The Flexa Thema, models ELT
F
eatures 4 simultaneous jets, whose action involves the lum-
bar area of the body. In the Thema 100 and 120 models, the
layout of the jets was designed so that the two lower ones act
on the calves.
•
Adjust the water temperature and set up the function as indi-
cated in the chapter on the "Shower" function.
• (fig. 1) Turn the knob to the indicated symbol. Water will be dis-
pensed from the lumbar jets (fig. 2-2a).
(fig. 3) The intensity of the massage, or the form (or pattern)
of each jet can be modified by turning the appropriate ring nut.
If you turn it clockwise you will have a fan-shaped spray; if you
turn it counter-clockwise you will have a single, concentrated
jet.
Also, the jets can be inclined about 7° in any direction.
Remember to close the mixer and to place the devia-
tor on "outlet below seat" (fig. 4). If there is a thermo-
static mixer, turn the corresponding knob to below 38
°C (fig. 5) and also close the stop tap.
NOTE
1
2
3
2a
4
5
To Next Page
Loading...
