53
J-400
1. From the “Water Care” Menu you can to set the CLEARRAY UV bulb
timer, Figure 12.6c.
2. Tap or to change the days in 10-day increments. The range is
from OFF to 365 days. The CLEARRAY UV timer counts down by
days not usage.
Note: It is not recommended that this feature be turned OFF. In order to
continually have the CLEARRAY system effectively preform its function,
it should be program as instructed.
3. Tap to conrm and save your changes.
4. Tap to return to the “Water Care” Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display, page 75. The CLEARRAY UV bulb must be replaced
(page 70) and the timer must be reset. Tap “reset” and follow
the instructions above to reset the timer. If you tap “snooze” the
message will clear but the error icon will display and the reminder
screen will reappear in 10 days.
B. Programming the Water Change Timer
A programmable “Water Refresh” reminder can
be set to remind you when to drain and rell the
spa. Tap
Water Refresh
60
(Figure 12.6b) to enter
the Programming Menu.
1. From the “Water Care” Menu you can to set
the “Water Refresh” timer, Figure 12.6d.
2. Tap or to change the days in 30-day
increments. The range is from OFF to 180 days.
Note: It is not recommended that this feature be turned OFF. In order to
continually maintain the water healthy and clean, in addition to chemical
maintenance, it should be program as instructed.
3. Tap to conrm and save your changes.
4. Tap to return to the “Water Care” Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display, page 76. The water must be drained and replaced with
fresh water. Follow the instructions above to reset the timer. If you
tap “snooze” the message will clear but the error icon will display
and the reminder screen will reappear in 10 days. Refer to Section
13.1, page 59, for lter location.
60
60 days left
add
days
Water Refresh
Figure 12.6d