60
J-400
A. Cleaning the lters and lter bag
To ensure optimum performance:
1. The ProClarity™ lter cartridge (A) must be
cleaned every month and replaced every 18
months.
2. The ProClarity Depth lter (B) must be replaced
every 3 months.
3. The ProClarity lter canister (C) can be rinsed
when the lters are cleaned.
4. The ProClear II skimming lter cartridge (D)
must be cleaned every month and replaced every 18
months.
5. The ProClarity debris bag (E) should be checked and
emptied monthly.
To accomplish this, refer to the following lter cleaning
procedure. The primary lter cartridge goes on the side that
has the wall tting with the grid, Figure 13.1b.
Note: Do not attempt to wash the ProClarity depth lter (B) and the
ProClear/ProClarity debris bag (E) or it will come apart!
B. Cleaning the Filters/Debris bag:
A
DANGER: TURN POWER TO SPA OFF! TO DECREASE
RISK OF DEATH, DROWNING, OR ENTRAPMENT, NEVER
OPERATE SPA WHEN FILTER IS NOT PROPERLY INSTALLED
OR IF SKIMMER ASSEMBLY IS DAMAGED OR ALTERED!
B
(Spa
Shell)
Lift the cover upward to
access lter cartridges.
C
Remove the ProClarity
debris bag from clips
and then clean out
debris.
D
(Spa Shell)
Rotate each lter
cartridge handle
counterclockwise to
unthread from mating
wall tting.
A
B
C
D
E
Figure 13.1b
Debris
Bag
To Next Page
Loading...
Need help?
General
