2323
Pour 50-100 ml of J-MX 07 liquid into the tub.
Activate the hydromassage for just over 1 minute; leave the
liquid to act for at least a further 15 minutes.
Open the drain and empty the tub.
TROUBLESHOOTING...
The hydromassage does not activate
- Check that the main switch is on.
The “strength” of the hydromassage has got weaker
- Clean the air and hydromassage outlets (refer to the Chapter,
“Maintenance”).
MAINTENANCE
ATTENTION! Before carrying out any maintenance op-
eration, disconnect the appliance from the power sup-
ply line.
Cleaning the air outlets
Remove any residue and wash the various components with wa-
ter and soap.
Cleaning the tub and the taps and ttings
Use non-abrasive or powder detergents.
Do not use acetone or other solvents.
To Next Page
Loading...
