Setting Your Clock:
To set your clock:
1. Press MENU twice until CLK appears on the screen. Press ENTER to set time.
2. Use UP or DOWN arrow to set hour. Press ENTER.
3. Use UP or DOWN arrow to set minutes. Press ENTER again and select AM or PM.
4. Press ENTER to accept. The LCD screen will then flash 3 times to indicate the new
setting has been saved. Press MENU to exit to Main Menu.
Setting Timer Periods:
To set timer periods:
1. Press MENU to go to TMRS (timer settings) and press ENTER to change.
2. Timer 1 is preset to begin at 8 am. Use the UP or DOWN arrow to change to desired
time. Press HIGH, MED, or LOW to select desired speed during Timer 1. On the
screen, HIGH is represented by “1”, MED by “2”, and LOW by “3”.
3. Press ENTER to move to the end time of Timer 1. Use the UP or DOWN arrow to
change to desired end time.
4. Timer 2 will now appear on the LCD screen. Repeat steps 1-3.
5. Timer 3 and Timer 4 are preset to OFF. Moving any timer to midnight will turn that
timer period off. Use the UP or DOWN arrow to activate the time and repeat steps 2-3
to set timer periods.
Configuration Menu:
To enter the Configuration Menu, press and hold ENTER for five seconds.
TMRS: This menu enables and disables all J-VSP timers and comes
preset in the ON position.
SYS: This menu enables and disables the J-VSP pumps ability to
communicate with any Jacuzzi equipment, such as HS interface
adapter. This comes preset in the OFF position.
DIM: This menu controls the brightness of LCD display and can be
adjusted using the UP and DOWN arrows to desired brightness.
FOR ADDITIONAL QUESTIONS, PLEASE CONTACT THE JACUZZI HOTLINE AT 1-844-615-8994 OR JACUZZI
SUPPORT AT questions@jacuzzipool.com.
To Previous Page
Loading...
Need help?
General
