SECTION TWO: TROUBLESHOOTING:
Warning:
I need to repeat the warning given at the beginning of this manual. If you don’t
have a working knowledge of electricity and can safely work with electricity, then
you should have a licensed electrician or properly trained service repairman
handle electrical problems. We try to make this information safe but we can’t
cover all possibilities. Just make it a routine to turn off main power when doing
any service. There are only a handful of times you might have to do tests that
require power to be on. Special care must be given in those situations. Also,
although some troubleshooting is reasoning on the problem and observing what
is happening, at times the definitive test will require use of a volt/ohm meter.
Again, if you are knowledgeable of their use it makes it easier to isolate the
problem. But if you are not comfortable using a meter, it’s best to consider
experience help.
To Next Page
Loading...
