29
Limitation of electricity consumption
If you do not have enough electricity and decide to turn the con-
sumption limiter on, you must congure the system software as in-
dicated (refer to the wiring diagrams to identify the type of electrical
box on board the hot tub).
X Make sure the spa is disconnected from the power supply line.
X Remove the cover of the electrical box and set the switch
("dip-switch") n ° 1 to the OFF position.
12345678
ON
Q PROFILE "TOP"
X In the OFF position, the electric heater switches o when a
whirlpool pump is activated.
Q PROFILE "BASE" DSP
X In the OFF position, the electric heater switches o when the
whirlpool pump is activated in high speed.
NOTES
- When dipswitch 1 is set to ON, the maximum electrical consump-
tion is selected.
Check of operation
First start-up
XCheck that the lter cartridge is present in its container and
that the various components are properly installed (see the chap-
ter on maintenance of the lter cartridge).
A
A
XCheck that the drain valve (V) on the base (and the ball valve
V1, if installed) are closed.
V1
V
XCheck that all the hydromassage intakes are open.
To Next Page
Loading...
Need help?
General