29
Turn the compression key to the “open” position in the direction of the arrow.
Crown A will then be in position 1. A few clockwise turns of the crown will sufce
to start the watch. It will then automatically wind up when you wear it. Please note
that the crown does not lock on winding, even when the watch is fully wound.
Once the operation is complete, turn the compression key to the “closed”
position in the direction of the arrows.
Setting the hour and minute
Crown A
Turn the compression key to the “open” position in the direction of the arrow.
Then pull crown A out to position 3.
The movement will be locked and the operating indicator will stop. Move the
hands clockwise until the desired time is displayed. Once the operation is com-
plete, push the crown back into position 1. The watch will start running again.
Then turn the compression key to the “closed” position in the direction of the
arrows.
Operating indicator
The seconds disc completes one revolution in 60 seconds. It also shows you that
the watch is running.
Setting the date
Crown A
123
English
To Next Page
Loading...
Need help?
General
