To Next Page

To Previous Page

CONNECT BOTH EARBUDS

STEP ONE – TURNING OFF THE EARBUDS

Place earbuds back in case or press and hold multi-

function button for 5 seconds to turn off. Your earbuds

will automatically turn on when taken out of the portable

charging case. If you need to turn them on manually, you

can quick press the multi-function button once on both

earbuds.

STEP TWO – CONNECTING THE EARBUDS TO

EACH OTHER

When you take the earbuds out of their case, they will

automatically sync to each other, and the LEDs will turn

solid blue for 5 seconds. Your earbuds will then go into

pairing mode and begin searching for a Bluetooth device,

and the LEDs will quick ash blue.

If your earbuds don’t sync to each other automatically,

please check to make sure they are charged and turned on.

STEP THREE - CONNECTING TO A DEVICE

Enable Bluetooth on your device. From the Bluetooth

menu, select “Ultra”. When the device and Ultra are

connected, you will hear a tone. This means pairing is

complete.

ULTRA

Bluetooth

Devices

Questions and Answers:

Need help?

Do you have a question about the Jam Ultra HX-EP910 and is the answer not in the manual?

Jam Ultra HX-EP910 Specifications

General