JAMEC PEM TDR3000

BATTERY CHANGE
This inator requires 2 x AAA batteries. If the voltage of the batteries fall
below 2.6 volts, the battery icon will ash continuously until it shuts down.
If the voltage of the batteries fall below 2.5 volts, the low “LO” battery icon
appears while the power is on and then shuts down automatically. The
batteries must be changed if the battery icon ashes.
1. Unscrew the battery cap
TDR3OOO
32..0
PSI
Scale
change
button
2. Slide the batteries into the inator with the positive
end facing out of the inator
3. Replace the battery cap carefully and do not over
tighten
SCALE CHANGE
Press and hold the scale change button to activate the display, once the
display is activated press and hold the button for 2 seconds to change the
display scale.