2
TDR3000 Automatic Tyre Inator
Thank you for selecting our TDR3000 Automatic Tyre Inator, please read this manual
carefully before using.
This manual is an important part of this product and be should stored safely for future
reference. It should be made available for new operators and maintenance personnel.
We reserve the right to change product features at any time.
IMPORTANT
This tyre inator must only be connected to air line systems which have clean dry air.
Any moisture in the air line system may cause damage to the operation of this tyre
inator and void warranty.
Operation
■
To read pressure:
Place hold-on chuck squarely and rmly onto tyre valve, before each pressure reading
fully depress lever and release.
Check pressure gauge, the digital display will activate once the tyre pressure is
sensed. If no pressure is sensed the display will not turn on, please press trigger to
add air into tyre, before reading pressure.
■
To inflate:
Place hold-on chuck squarely and rmly onto tyre valve.
Fully depress lever for an appropriate period of time and release lever.
Check pressure gauge and repeat procedure until correct pressure level
is achieved.
■
To deflate:
Place hold-on chuck squarely and rmly onto tyre valve.
Depress lever half way (until air can be heard escaping) for an appropriate period of
time and release lever.
Check pressure gauge and repeat procedure until correct pressure level is achieved.
Safety
■
Never exceed the maximum pressure of the tyre.
■
Check that hose and chuck are in good condition with no damage or cracks.
■
Ensure safe working environment when using compressed air.
■
Place hold-on chuck squarely and rmly onto tyre valve.
■
Return to authorised service agent for repair and maintenance.
To Next Page
Loading...
Need help?
General