JAMEC PEM TDR3000 User Manual

3
TDR3OOO
Part No. 10.3012
32.0
PSI
Instruction Manual
Scale
change
button
Battery Change
This inator requires 2 x AAA batteries. If the voltage of the batteries fall below 2.6 volts, the battery icon
will ash continuously until it shuts down. If the voltage of the batteries fall below 2.5 volts, the low “LO”
battery icon appears while the power is on and then shuts down automatically. The batteries must be
changed if the battery icon ashes.
Scale Change
Press and hold the scale change button to activate the display,
once the display is activated press and hold the button for 2
seconds to change the display scale.
1. Unscrew the battery cap
2. Slide the batteries into the inator with the
positive end facing out of the inator
3. Replace the battery cap carefully and do
not over tighten
WARNING
Important: To avoid the risk of personal injury, especially to the eyes, face or skin, DO NOT
direct the aim stream at any person or body parts

JAMEC PEM TDR3000 Specifications

General

Brand	JAMEC PEM
Model	TDR3000
Category	Power Tool
Language	English