OPERATION INSTRUCTIONS
6
Open the cover, and place the object to be cleaned into the
stainless steel tank.
Then, using a jug, ll the stainless steel tank with normal tap water.
The liquid must cover the object that is to be cleaned, but must
not exceed the mark indicating the maximum lling height.
Never use the ultrasonic cleaning device without
water as you will damage the device!
Close the cover and insert the mains plug.
The gure 180 (180 seconds) appears in the display as standard
- this is the standard time for a normal degree of soiling.
Select the desired time from ve possible intervals:
Use the SET button to set the desired time according to the
degree of soiling.
Press ON switch and start the cleaning process.
The blue indicator lamp in the housing lights up while the time
shown in the display counts down to 0.
Note: During cleaning process a quiet vibration noise can
be heard; this is caused by the cleaning process.
After the set time has elapsed the cleaning process is automatically
stopped, the blue indicator lamp goes off and the display
shows 000.
3
180s 300s 480s 90s 600s
To Next Page
Loading...
