What to do if JAMO S 502 remote control is not working?
If the JAMO S DVR 52 unit isn't responding to the remote, there might be a few reasons. First, make sure there are batteries inside the remote, and if there are, try replacing them with new ones. Also, ensure you're pointing the remote directly at the remote sensor on the S DVR 52 unit and that you are within 5 meters of the unit.
Why is there no sound from my JAMO S 502?
If you're not getting any sound from your JAMO Home Theater System, there are a couple of things to check: * Ensure that the volume isn't set to 0. If it is, increase the volume. * Also, verify that the speaker cords are correctly connected. If they aren't, connect them properly.
What to do if my JAMO Home Theater System has no picture?
If there's no picture on your JAMO Home Theater System, the TV might be switched off, so turn it on. Also, check if the TV is connected correctly; if not, connect it correctly.
What to do if my JAMO S 502 Home Theater System disc can’t be played?
If your JAMO Home Theater System isn't playing a disc, consider these possibilities: * Make sure the disc label is facing up. * The disc might be empty or in an unsupported format; try another disc. * The disc could be dirty or damaged; clean or dispose of it. * The disc might not be correctly placed within the disc tray guide; ensure it is properly placed.
What to do if my JAMO Home Theater System power is not supplied?
If your JAMO Home Theater System isn't getting power even when the cable is connected, make sure the power plug is securely connected. Also, verify that the wall plug is turned ON; if not, turn it ON.
Configure aspect ratio for TV display.
Select TV system compatibility (NTSC/PAL).
Turn screen saver ON and OFF.
Select video output resolution (SD, 720P, 1080i).
Choose video output type (YUV/RGB).
Select Centre-channel delay time for Dolby Digital audio.
Select rear channel delay time for Dolby Digital audio.
Test speaker connection correctness.
Reduce dynamics (loud sounds) by activating dynamic range function.
Select SPDIF/RAW or SPDIF/PCM output settings.
Sets the OnScreen Display language for the S DVR 52.
Select the preferred audio language for the DVD.
Select the preferred Subtitle language for the DVD.
Select the desired Disc Menu language for the DVD.
Steps to select a USB device for playback.
Instructions for browsing and selecting files for playback.
How to select pre-programmed radio stations using remote.
Steps to manually tune and save radio stations.
Automatically scans and stores all available radio stations.
Switch between stereo and mono for better reception.
Information about RDS data display.
Information regarding disposal and recycling.
Information about product copyright and trademarks.
Instructions for contacting service and warranty claims.
Details of the warranty period and coverage.
Conditions and limitations of the product warranty.
Guidelines for packaging the product for shipping.
General| Speaker Type | 2-way bassreflex |
|---|---|
| Impedance | 6 Ohm |
| Driver Configuration | 1 x 1" tweeter |
| Tweeter Size | 1 inch |
| Crossover Frequency | 3000 Hz |
| Woofer Size | 102 mm / 4 in |
| Weight | 6.6 lbs |
To Next Page
