Jandy Pro Series Levolor II User Manual

WARNING
INSTALLATION AND
OPERATION MANUAL
H0303700 Rev C
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualified in pool
equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. The
maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that
all of the instructions in this manual can be followed exactly. Before installing this product, read and follow all warning
notices and instructions that accompany this product. Failure to follow warning notices and instructions may result in
property damage, personal injury, or death. Improper installation and/or operation will void the warranty. Improper
installation and/or operation can create unwanted electrical hazard which can cause serious injury, property damage,
or death.
ATTENTION INSTALLER - This manual contains important information about the installation,
operation and safe use of this product. This information should be given to the owner/operator of this
equipment.
Jandy Pro Series Levolor
®
II
Electronic Water Leveler
Model K-2000
Power Sensor Filling
Electronic
Water Fill
System
The next generation
in automated controls.
Patented
High Voltage Compartment
No user service parts inside
Model No. K-2000
High Water High Water
Sensor Pump
II
LEV
olor

Jandy Pro Series Levolor II Specifications

General

Lens Material	Polycarbonate
IP Rating	IP68
Type	Underwater Light
Voltage	12V
Color Options	White

Summary

Safety Information

General Safety Warnings

Summarizes critical safety precautions, warnings, and cautions for product installation and use.

System Description

Electrical Specifications

Details the input voltage, frequency, and current requirements for the electronic water leveler.

Sensor Description

Explains the three-probe sensor and its role in detecting water levels.

Control Box Overview

Describes the control box features, including its five LED status lights.

System Schematic

Provides a wiring diagram illustrating the interconnections of system components.

Installation Instructions

Materials and Tools

Lists all furnished installation materials and necessary tools for the K-2000 kit.

Installing the Control Box

Provides instructions for securely mounting the control box near the pool equipment.

Changing Wiring for 110 Volt Operation

Details the procedure to modify the unit's wiring for 110VAC power supply.

Grounding

Explains the correct method for grounding the control box and electrical system.

Installing the Valve and Relay

Guides the user on installing and connecting the solenoid valve and relay.

Installing the Sensor

Provides instructions for mounting and wiring the water level sensor.

Vanishing Edge Pool Installation

Specific installation guidance for pools featuring a vanishing edge design.

Operation

Controller Lights and Indicators

Explains the function of each LED indicator on the control box.

Fill Safety Lockout Mode

Details the safety feature that prevents continuous filling after a set period.

Pump On Delay Timer

Describes the delay setting before the high water pump activates.

Pump Off Delay Timer

Describes the delay setting before the high water pump deactivates.

Changing Jumpers and Dip Switches

Instructions for adjusting operational timers and settings using jumpers and dip switches.

Troubleshooting

Initial Jobsite Observations

Initial checks and observations to perform at the installation site before troubleshooting.

Test Operation of Control Unit

Procedures for simulating conditions to verify the control unit's functionality.

Fill Valve Will Not Turn OFF

Troubleshooting flowchart and steps for diagnosing fill valve shut-off issues.

Fill Valve Will Not Turn ON

Troubleshooting flowchart and steps for diagnosing fill valve activation issues.