Page 3
Jandy
®
Handheld Remote Control Outdoor Transceiver J-Box Assembly | Replacement Kit Instructions ENGLISH
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
WARNING
FOR YOUR SAFETY - This product must be installed and serviced by a professional pool/spa service technician. The procedures in this instruction
sheet must be followed exactly. Ensure that all electrical power to the system is turned off before approaching, inspecting or troubleshooting any
leaking valves that may have caused other electrical devices in the surrounding area to get wet. Failure to do so could result in an electrical hazard
which could result in death or serious injury due to electrical shock, and may also cause damage to property and/or operation will void the warranty.
CAUTION
ESD Precautions - Electrostatic discharge (ESD) events can harm electronic components inside your device. To prevent ESD damage, you should
discharge static electricity from your body before you interact with any of your devices internal electronic components, such as a printed circuit board
(PCB) or any connection terminals. You can also take the following steps to prevent damage from electrostatic discharge:
• When unpacking a static-sensitive component from its shipping carton, do not remove the component from the antistatic packing material until
you are ready to install the component. Just before unwrapping the antistatic package, be sure to discharge static electricity from your body.
• When transporting a sensitive component, first place it in an antistatic container or packaging.
WARNING
Risk of Electric Shock which can result in Serious Injury or Death.
Before attempting installation or service, ensure that all power to the circuit supplying power to the system is disconnected or turned off at the circuit
breaker.
All wiring must be done in accordance with the National Electric Code (NEC), NFPA-70. In Canada, the Canadian Electrical Code (CEC), CSA C22.1,
must be followed. All applicable local installation codes and regulations must be followed.
This document gives instructions for replacing the Jandy Handheld Remote Control Transceiver J-Box
assembly, gasket, and screws. These instructions must be followed exactly. Read through the instructions
completely before starting the procedure. Please save these instructions.
To identify the parts that are included in your kit, refer to the parts list and exploded view located on page
2 of this manual. If any parts are missing from the kit please call your local Jandy distributor for assistance.
Fortechnical assistance please contact our Technical Service Department at (800) 822-7933.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...