I. ADJUSTING THE HANDLEBAR
The handlebar can be set to 7 different positions. Simultaneously
press the buttons on both sides of the handlebar.
14
J. SEAT BELT
Your pushchair has a safety harness to keep your child safe at all ti-
mes. Fit the belt onto the child whenever he is using the pushchair.
15
15.1 To open the belts, press the button in the middle of the harness.
15.2-15.3 To fasten it, bring the two side straps together and then
insert them into the harness until they click into place.
15.4 Adjust the belts so that they t the child correctly with the right
tension. To adjust the length of the belts, slide the buckles up or
down. Make sure that the belts are not twisted.
K. USE WITH INFANTS UNDER 6 MONTHS
To use the seat with children under 6 months old, adjust the angle
of the seat to the most reclined position.
10
.a
Adjust the harness to the lowest position.
15
.a
L. ADJUSTING THE FOOTREST
The footrest can be adjusted to 5 different positions. Use your
thumb to simultaneously press the two buttons on the lower part of
the hammock.
16
M. USING THE PARKING BRAKE
PUTTING THE BRAKE ON: Push the operating lever on the right of
the handlebar down to activate the parking brake of your stroller.
17
TAKING THE BRAKE OFF: Press the release button and move the ope-
rating lever on the right of the handle bar upward to release the
parking brake..
17
.a
To adjust the brake:
If you need a more precise adjustment follow the indications in gu-
re..
18
WARNING: When the brake is on make sure that the pushchair
has braked correctly. It may be necessary to push the pushchair
slightly for the brake to be fully activated.
!
IM 1683.02 CROSSWALK 27-10-16 adv.indd 29 27/10/16 11:29
To Next Page
Loading...
