Need help?Do you have a question about the Janome CoverPro 1000CP and is the answer not in the manual?
General| Type | Coverstitch |
|---|---|
| Stitch Length | 1 - 4 mm |
| Differential Feed | Yes |
| Free Arm | Yes |
| Needle Positions | Left, Center, Right |
| Presser Foot Lifter | Manual |
| Thread Tension | Manual |
| Built-in Needle Threader | No |
| Stitch Options | Chain Stitch |
Procedure to remove and attach the machine's face plate.
Steps for removing and reattaching the belt cover.
Guide for removing and attaching the looper cover.
Instructions for removing and installing the rear cover.
Steps to remove and attach the front cover.
Procedure for removing and reattaching the free arm cover.
Setting the correct distance between the presser foot and needle plate.
Adjusting the pressure of the presser foot.
Setting the needle bar height for different models.
Adjusting the maximum height of the feed dogs.
Setting the correct height of the looper point.
Aligning the looper point with the right needle.
Setting the timing when looper meets the needle.
Ensuring proper clearance between needle and looper.
Setting the back needle guard height relative to the looper.
Timing the needle and feed dogs for correct operation.
Setting the desired stitch length for sewing.
Adjusting the differential feed for fabric handling.
Setting standard thread tensions for different threads.
Procedure for replacing the motor and adjusting belt tension.
To Next Page