81
LIGHTING: TURN INDICATORS
TURN INDICATORS (see left)
Your Janus is equipped with turn indicators that use a 12 volt RY10w incandescent bulb.
WARNING: The bulb andlens become hot during operation. Always allowsufficient time
for the light to cool before servicing.
TURN INDICATOR BULB REPLACEMENT
1. Unscrew the two turn indicator light retaining screws, taking care not to lose the rubber
gaskets.
2. Carefully remove the turn indicator lens.
3. Unscrew the bulb and replace with a new bulb.
4. Replace the lens an lens retaining screws.
WARNING: Always replace with the correct bulb specified above. Operation with an
incorrect bulb can under or over-load the electrical system, leading to electrical failure,
loss of control, and anaccident.
LED OPTION: LED bulb replacement is the same as with the incandescent bulb. Only
use LED replacements available from Janus Motorcycles.
To Next Page
Loading...
