6-4-1. Setup
3
4
5
6
7
2
1
1. Frame : Setup recording frames (Available setup for each channel)
2. Event frame : Setup frames of event occurs. (Pre-Alarm and Post Alarm)
Pre-Alarm – 2 ~ 5 seconds to adjustable before event.
Post-Alarm – 10 ~ 30 seconds to adjustable after event.
3. Quality : Recording Quality control
4. Disk Usage : Setup the disk usage
Once – If the SD memory card is full, stop recording forward.
Recycle – If the SD memory card is full, start to over write from the beginning.
5.Time Zone : Set up time zone by each country.
6. Over speed setup : setup over speed limits.
7. Event on/off : Activate event setting by types such as emergency, impact,
Over speed, sudden brakes and sudden accelerate.
21 page
To Next Page
Loading...
Need help?
General
