QUICK START GUIDE
Put the monitor face down on a stable and smooth surface, pay attention not to damage or scratch the front glass /
screen. It’s better putting a soft piece of cloth on the table beforehand to protect the monitor. Make sure the monitor
is unplugged before starting installation.
SETTING UP THE MONITOR
1. Put the monitor face down on a stable and smooth surface; make sure you have enough space to operate safely.
2. Make sure you have the base kit with all his parts (6 screws / 3 stand parts) to set up the monitor correctly.
3. Secure the bracket and stand with the included
screwdriver and screws as per the below picture.
4. Put the base kit on the back side of the display as
per the below picture.
4. Fix the stand kit to the back side of the monitor as per
the above picture. Screw without force.
5. Make sure the stand and base are firmly attached.
6. Make sure both monitor and computer are unplugged.
7. Plug power cord and signal cable (HDMI or DP) to the monitor.
8. Plug the computer and monitor power cord to the power supply.
9. Turn on the monitor and computer.
NOTE / CAUTION
After turning on computer and monitor if no image is displaying make sure you have chosen the right signal cable.
Please make sure to earth the power cord.
To Next Page
Loading...
Need help?
General
