Need help?Do you have a question about the Jasco ZW3103 and is the answer not in the manual?
General| Brand | Jasco |
|---|---|
| Model | ZW3103 |
| Category | Lighting Equipment |
| Language | English |
Product may turn power ON when load changes; unplug before service.
Exercise caution when controlling appliances; avoid unintentional activation.
Every Z-Wave device acts as a repeater, extending network range and eliminating dead-spots.
Obstacles like walls and appliances reduce wireless range by 25-30%.
One Z-wave outlet for incandescent or dimmable CFL/LED lighting.
Features an additional outlet that is always powered on.
Notes potential interference from 900MHz devices and provides channel selection advice.
Explains three ways to turn the light on: remote, manual button, or load-sensing.
Details controlling individual devices, groups, and scenes with Z-Wave remotes.
How to use the front panel pushbutton for ON/OFF toggle.
How to adjust lighting brightness by pressing and holding the button.
Procedure to add or remove the module from your primary Z-Wave controller.
Requires an advanced controller like the model 45601 LCD remote.
Configures how the module responds to network-wide ON/OFF commands.
Explains how to enable Load-Sensing using parameter 29.
Adjusts dimming steps and timing for Z-Wave dim commands (Parameters 7 & 8).
Adjusts dimming steps and timing for manual button presses (Parameters 9 & 10).
Adjusts dimming steps and timing for All-On/All-Off commands (Parameters 11 & 12).
Resets all configuration parameters to their factory default settings.
Addresses issues with exceeding maximum power rating and over-current protection.
Discusses integrating different Z-Wave devices and controller requirements.
Details the two-year limited warranty for manufacturing defects.
Addresses potential radio/TV interference and user corrective measures.
Device must not cause interference and must accept all interference.
Lists power, frequency, load limits, fuse rating, operating temperature, and indoor use.
Indicates Z-Wave is a registered US trademark of Sigma Designs.
To Next Page