Jata electro BT575 - Instructions for Use; Blender Stick Operation; Rod Functioning and Speed Selection; Maintenance and Cleaning

9
• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always disconnect it from the mains when you do not use it
and before assembling / disassembling or when cleaning.
• Do not leave the blender plugged in if it is not going to be used.
• Take all necessary precautions while handling the blade, as it is
very sharp. The wrong using of the appliance can cause injury.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTIONS OF USE
• Beforeyouplugtheblenderin,assembletheaccessoryyouaregoingtouse.
• VERY IMPORTANT: The rods with the slots in the edge must be placed in the toothed hole of the blender.
- MIXINGRODS(8):Forliquidmixes,creams,eggwhites,etc.
- KNEADINGRODS(9):Theyaredesignedtokneadpastryandlightdough.
• Placetherodsinthecorrespondingholespressingandturningroundinordertohavethemcorrectlyxed.
Usealwaystherodstogether.Neverusedierentrodstogether.
BLENDER STICK (6)
• Itisscrewedintothethreadedhole(5).Toplaceit,slidethelidofthestickblenderupwardsuntiltheendand
keepitinthatpositiontoscrewthestickblender.
• Theblenderstick(6)mustnotbeplacediftherodsarealreadyplaced.
BLENDER STICK FUNCTIONING.
• The blender stick only works keeping pressed the pusher “TURBO” having the speed selector (4) in “1”
position, when that pusher is released the blender stops.
RODS FUNCTIONING
• Selectthespeedwiththeselector(4).
• Itisadvisabletobeginatthelowestspeed(position1)tothenincreasethespeedtohighestspeed(position
5).However,anddependingonthetextureofthefood,youmayusethehighestpositionfromthestart.
NOTE:Beingworkingwiththerods,theappliancewillworkwithitsmaximumspeedifyoukeeppressedthe
turbopusher(2),independentlyofthepositionofthespeedselector(4).
• Onceyouhavenished,setthespeedselector(4)to“0”positionandunplugitfromthemains.
• Totakeouttherods(8-9)fromthemainbodypressthereleasebutton(3).
• ATTENTION: Therodscanonlybereleasedwhenthespeedselector(4)isinthe“0”position.
MAINTENANCE AND CLEANING
• Beforeyouproceedtocleaning,makesuretheapplianceisunpluggedfromthemains.
• Theaccessoriesmaybecleanedwithsoapandwater.Trytodoitassoonasyounishusingit,becausedry
textureofsomefoodsarediculttotakeout.
• Cleanthebodyoftheblenderwithaclothdampenedinwater.
• Donotuseabrasiveorchemicalproducts,suchasmetallicscourers,whichmaydeterioratethesurfacesof
theappliance.
ENVIRONMENT PROTECTION
• Disposetheapplianceaccordingtothelocalgarbageregulations.
• Neverthrowitawaytotherubbish.Soyouwillhelptotheimprovementoftheenvironment.
01 manual jata maestra bt575.indd 9 15/05/18 13:06