Jata electro PL622C - Operating Instructions; Ironing Modes; Auto-Cleaning System; Maintenance and Cleaning

12
• The cleaning and maintenance done by users, can not be done
by children without any supervision.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualied
personnel in order to avoid a danger.
INSTRUCTIONS OF USE
STEAM IRONING
• Set the temperature selector (7) to its maximum position (MAX) by turning it clockwise.
• Before lling the tank with water, set the adjustable steam knob (3) to the o position (0).
• To ll the tank, always do so with the iron unplugged from the mains.
• Open the lling lid (4) and pour water into the tank using the cup provided.
• Do not go over the MAX indication of the tank (8) to avoid overowing.
• Replace the lid.
• Connect the iron to the network. The indicator (9) will light up.
• Place the steam iron in vertical position.
Attention:
It is important to place the iron in vertical position.
• Once the pilot light (9) goes o, turn the steam knob (3) to the maximum steam indication (
) until getting
the desired amount of steam.
SUPER STEAM
• The temperature selector (7) must always be set to its maximum position (MAX).
• Press and release the button (2). Repeat this operation at intervals between each time you press the button.
• If you wish to obtain a greater super-steam set the steam control knob (3) to the o (0) position.
VERTICAL IRONING
• It allows you to remove creases from the garments without them having to be lying on the ironing board:
jackets and coats may be pressed on their hangers; as may be hanging curtains and such.
• Close the adjustable steam knob (3) and place the temperature selector to the (MAX) position.
• Bring the iron close to the garment in a vertical position and press the steam button (2).
SPRAY IRONING
• To obtain a spray, the temperature selector (7) position is unimportant.
• Press the spray button (1). In case no water should come out, press the button again.
DRY IRONING
• If there is water in the tank, set the adjustable steam knob (3) to the o position (0).
• Plug the iron into the mains and place the selector (7) in the desired temperature for each fabric:
- FIBRAS SINTÉTICAS: SINTHETIC FIBRES: Low temperature (•)
- SEDA – LANA: SILK – WOOL: Medium temperature (••)
- ALGODÓN – LINO: COTTON – LINEN: High temperature (•••MAX)
AUTO-CLEANING SYSTEM
• Set the adjustable steam knob (3) to the o position (0).
• Pour water into the tank.
• Set the temperature selector (7) to MAX position and plug the iron to the mains.
• As soon as the indicator light (9) is o, place the iron in a horizontal position on a plate or suitable container
in the sink and remain pressed the auto-cleaning CALC CLEAN (6) button. The steam and drops of water will
begin to ow from the orices in the base of the iron draining the dirt and particles.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning the appliance ensure the appliance is unplugged from the mains and let the
appliance to cool.