Jata PL120 - Advanced Ironing Modes

19
• To ll the tank, always do so with the iron unplugged from the mains. Open the
lling lid (4) and pour water into the tank using the cup provided.
• Do not go over the MAX. indication of the tank (8) to avoid overowing.
• Replace the lid.
• Plug the iron into the mains. The indicator (7) will light on.
• Once the indicator light (7) goes out, turn the steam knob (3) clockwise
according to the desired quantity.
SUPER STEAM
• The temperature selector (6) must always be set to its maximum position
(MAX).
• Press and release the button (2). Repeat this operation at intervals between
each time you press the button.
• If you wish to obtain a greater super-steam set the steam control knob (3) to
the o ( ) position.
VERTICAL IRONING
• It allows you to remove creases from the garments without them having
to be lying on the ironing board: jackets and coats may be pressed on their
hangers; as may be hanging curtains and such.
• Close the adjustable steam knob (3) and place the temperature selector to
the MAX. position.
• Bring the iron close to the garment in a vertical position and press the steam
button (2).
SPRAY IRONING
• To obtain a spray, the temperature selector (6) position is unimportant.
• Press the spray button (1). In case no water should come out, press the button
again.
DRY IRONING
• If there is water in the tank, set the adjustable steam knob (3) to the o
position ( ).
• Plug the iron into the mains and place the selector (6) in the desired
temperature for each fabric:
- FIBRAS SINTÉTICAS: SINTHETIC FIBRES: Low temperature (•).
- SEDA – LANA : SILK – WOOL: Medium temperature (••).
- ALGODÓN – LINO: COTTON – LINEN: High temperature (•••MAX).