Replacing the battery: remove battery cover on the back side of the
indicator, and insert R9/6LR61 9V alcaline battery (not included),
observing the correct polarity (+/-), and then close the cover.
Mount the alarm on a buzzer bar or bank stick.
Press and hold ON/OFF (C) few seconds to switch on/off indicator.
Thread the fishing line over the roller sensor (A). A bite is indicated by
sound and flashing lights (B).
To adjust required volume level press ON/OFF (C), repeat until mute.
To switch indicator OFF press and hold ON/OFF (C) few seconds.
Replacing the battery: remove the cover on the back of the receiver,
and insert 3 AAA 1,5V alkaline battery (not included) observing the
correct polarity (+/-) and then close the cover.
To switch on/off the receiver press and hold ON/OFF button(4).
Press V (3) to adjust volume level or mute, press and hold few seconds V
(3) to switch on/off vibes.
Bite is indicated by sound and flashing LED color according to activated
indicator.
To Next Page
Loading...
General