ENGLISH
SET-UP, ADJUSTMENT, & CARE
LENGTH ADJUSTMENT
For a longer seat length, position Solid Drop Seat I" (2 cm) forward
of the rear vertical posts of your wheelchair. lf front hooks are
less than I" (2 cm) from front end of seat rails, then remove front
hooks and move them to the alternate location directly behind
(see picture).
Fitting Hint:
Once you have determined the position of your Solid Drop Seat on
your wheelchair, you may find that the hooks interfere with the
hardware that is particular to your wheelchair. If this is the case,
reposition those particular hardware hooks to an alternate
location.
EASY MAINTENANCE AND CLEANING
Remove the cover and tum it inside out. Machine wash on warm
cycle and tumble dry on low heat. Do not use industrial dryers. Do
not steam autoclave. Wipe to clean the fluid pad with warm water
and towel dry. Do not submerge in water. Water may be absorbed
into the foam through the air vents on the top of the pad. Wipe to
clean the foam base and towel dry.
Note: When the cover is removed from the cushion for cleaning
inspect the fluid pad and foam base for unusual wear. Feel the
fluid for any inconsistencies. If inconsistencies are found, knead
the fluid pad to original consistency and/or call Jay customer
service at Sunrise Medical at 1-800-648-8282.
REASSEMBLING THE J2 DEEP CONTOUR CUSHION
AFTER CLEANING
Follow cleaning and maintenance instructions as described in
"Easy maintenance and cleaning", then reassemble as follows
after cleaning. Attach the fluid pad to the foam base. Attach the
rear three Velcro® strips first, then the front two Velcro® strips.
Reinstall the cover with the material I.D. tags to the back. If
necessary, reinstall the four hooks on the solid drop seat.
To Next Page
Loading...
Need help?
General
